OpenTTD | Higher bridges

Source

You do not have permission to edit this page, because you are not logged in.

You can view and copy the source of this page.

[[Translation:en/Archive/Manual/Higher bridges]]


{{en/Historic|Now bridges can always be built with any height}}
This [[en/Archive/Manual/Settings/Advanced Settings|setting]] enables you to build bridges at any height, not just one tile above the ground.

== Description ==
Originally, bridges could only be built at one-level above the ground they are spanning.  With this patch, it is possible to place bridges which span deeper gaps, as the picture shows.

Like normal bridges, this patch allows one end of the bridge to be started from a lower tile, provided the tile is flat.  This patch does not allow 'sloped bridges' (e.g. bridges that start from a height of 1 and end at a height of 3).

By default, when a higher bridge is built, pillars underneath the bridge are shown to the ground.  You may disable these by using the [[en/Archive/Manual/Settings/Bridge pillars]] patch.

== Use ==
This patch is always enabled and is not configurable.

<center>[[File:en/Archive/Manual/Higher bridges.png|center|frame|1. - Higher Bridges, in action.]]</center>

<center>[[File:en/Archive/Manual/Higher Bridges-Different Z.png|center|frame|2. - Higher Bridge starting on a flat tile at a lower height.]]</center>


[[Category:en/Manual/Settings & Preferences]]
[[Category:en/Manual/Construction]]

Source

Templates

Used on pages