OpenTTD | Double Cloverleaf

Source

You do not have permission to edit this page, because you are not logged in.
You can view and copy the source of this page.
[[Translation:en/Community/Junctionary/Double Cloverleaf]]

{{en/Community/Junctionary/Navigation}}
__TOC__
== 4-way 4-track Clover-in-Clover ==
An extended version of the [[en/Community/Junctionary/Cloverleaf]] for mainlines tracked AABB style (indicating the direction trains run in).
This junction use tunnels instead of bridges, because tunnels don't have speed limits.
As you can see on the image below, there are two tracks leading into the junction and two leading out: the whole reason for a double cloverleaf is to allow more traffic to flow through your line if you have a 4 track mainline.

[[File:en/Community/Junctionary/Double cloverleaf.png|none|thumb|590px|A double cloverleaf 4 way junction (horizontal extent 24; verical extent 24; needs 396 squares)]]

===Pros===
* Double tracked, holds twice the number of trains
* Can handle a large number of trains at the same time.
* Uses separate tracks so trains wont interfere with each other too much.

===Cons===
* Branching after merging: Very likely to enter a deadlock state.
* Extremely large
* Trains have to slow down when climbing a slope
* Trains have to turn right to turn left. This could lead to trains getting lost. (Can be fixed using [[en/Manual/Waypoints]])
* Doesn't have a direct path so that trains travel extra far to turn left.
* Costly to build
* Difficult layout to remember and to build

===Variations===
[[File:en/Community/Junctionary/DoubleCloverleafVariation.png|none|thumb|590px|A double cloverleaf 4 way junction without sharp corners, easier to remember, and more looking like a clover leaf.]]
[[File:en/Community/Junctionary/Rsz 1rsz campbell & co feb 29th 2000.png|none|thumb|590px|A double cloverleaf 4 way junction without sharp corners than the above, a little harder to remember, and more looking like a clover leaf.]]

== 6-way 2-track Double Overlap Clover ==
Taking two cloverleaf junctions and overlapping them together produces a 6-way junction. This is similar to the 4W4T clover, except that the mainline is signalled ABAB-style rather than AABB (train direction per track) and that trains can change over (an expensive operation the path finder tries to generally avoid).

It has the same extent as the Clover-in-Clover (24×24). Without the direct right turns, the extent shrinks to a compact box of 20×12.

[[File:en/Community/Junctionary/Two clover merged.png|none|thumb|590px|6-way double cloverleaf]]

== 8-way 2-track Quad Overlap Clover ==
Taking four cloverleaf junctions and overlapping them together produces an 8-way junction. (Again, if one ignores the space, it is a 4-way 4-track interchangeeven though the double tracks are separated by a void of 6 squares, combining them likewise, an 8-way junction can be obtained. This is similar to the 4W4T cloverleaf in that, when one considers the two 2-tracks , and handy when the mainline tracks are signalled ABAB style (indicating direction trains run in) rather than AABB.

[[File:en/Community/Junctionary/Quad clover merged.png|none|thumb|590px|8-way quadruple cloverleaf]]

[[Category:en/Manual/Train Junctions]]
Templates

Navigation
Source

Templates

Used on pages
